What Others
Are Saying!

“ ”

Tools needed:

Hardware needed for rail post installation

Please Note: Use only Stainless Steel mounting hardware with the Stainless Steel DeckLok Brackets and Hot Dip Galvanized mounting hardware with the Hot Dip Galvanized DeckLok Brackets. Brackets are available on our online order page.

Step 1:
Hold bracket against post and deck joist and mark holes.  Mark two holes on deck joist diagonally and one hole on rail post per bracket.

Step 2:
Using a 9/16” drill bit, drill all holes as marked

Single bracket external post corner install (1.2mb)
Single bracket external post install (1.3mb)
Double bracket internal post install (1.4mb)
Double bracket post between joists install (1.4mb)
All post installs (4.8mb)

Step 1:

Step 2:

Step 3:

Step 4:

Step 5:

Step 6:

• Two stair stringer install (1.1mb)
• Three stair stringer install (1mb)
• All Stair Stringer Installs (2.1mb)

Step 1:

Using the following diagram, determine the number of brackets needed and their locations. When anchoring the ledger board, DeckLok brackets are installed in pairs.

Step 2:

Position the bracket so the center hole will pass through both the band board and the ledger board.

Step 3:

Hold bracket against house floor joist, mark two holes for floor joist, one for house band board/deck ledger board

Step 4:

Temporarily install two bolts in the house joist. Slip 2nd bracket onto the bolts, mark center hole on house band board

Step 5:

Drill center hole

Step 6:

Install brackets on both sides of floor joist, bolt in and tighten hardware.